Heavy Hitter Zero XB 420 Primary Chain Drive Conversion Kit installed

The Heavy Hitter Zero XB 420 Primary Chain Drive Conversion Kit replaces the stock primary belt on the Zero XB with a 30-tooth 7075-T6 billet rear sprocket, a 13-tooth nitrided 52100 steel front sprocket, a shim and a 420 non-O-ring chain. Made by Heavy Hitter and sold here at GritShift, it weighs 1.34 lb and keeps the OEM gear ratio.

Specs verified October 2026 against the live GritShift product page and the Heavy Hitter tech sheet.

Specifications

Type 420 primary chain drive conversion, replaces the stock belt drive
Rear (jackshaft) sprocket 30-tooth 7075-T6 billet aluminum
Front (drive) sprocket 13-tooth, nitrided 52100 tool steel, with shim
Chain 420 non-O-ring Japanese chain with master link, included
Spacing shim 1 x spacing shim, included
Hardware Mounting bolts for the 30T sprocket are not included; reuse the OEM bolts
Weight 1.34 lb
Gear ratio Maintains the stock gear ratio and OEM motor alignment
Dampers None; vulcanized rubber sprockets were tested and rejected
Drive sprocket orientation E-Ride / #2 face outwards
Chain tension Loose, not tight
Tech sheet Heavy Hitter Zero XB 420 Primary Chain Drive Conversion Kit installation instructions (PDF)

What bikes does the Heavy Hitter Zero XB 420 chain kit fit?

  • Zero XB

Why convert the Zero XB belt drive to a 420 chain?

Heavy Hitter designed this kit for Zero XB riders running upgraded motors or controllers, because the stock belt cannot handle serious torque. Other chain kits solve the belt problem but add weight or rolling resistance; Heavy Hitter pairs a 7075-T6 billet rear sprocket to keep weight down with a nitrided 52100 tool steel front sprocket for durability, then runs a non-O-ring chain to keep resistance at a minimum. Heavy Hitter calls it the lightest 420 primary kit on the market with the least rotating mass. It is louder than a belt, but no louder than other chain kits, and it is race-proven on stock power and on high-power EBMX, Sotion and Torp setups.

What is in the box?

  • 1 x spacing shim
  • 1 x 13T drive (front) sprocket, nitrided 52100 tool steel
  • 1 x 30T rear sprocket, 7075-T6 billet aluminum
  • 1 x 420 non-O-ring Japanese chain with master link

Mounting bolts for the 30T sprocket are not included; reuse the OEM bolts. The tech sheet (PDF) numbers the three machined components for assembly.

How do I install the Zero XB primary chain kit?

The tech sheet gives the orientation for the Zero XB: fit the drive sprocket with the E-Ride / #2 face outwards, seat the shim flush against the sprocket face, then install and tighten the output shaft nut. Set the chain tension loose, not tight; Heavy Hitter states that any chain drive should run with loose tension, and the primary drive information page has more on primary drives. Precision machining keeps the sprockets aligned with the OEM motor so the drive stays smooth at high RPM. Sur Ron, Segway, E Ride, Ventus and Falcon owners need the separate Heavy Hitter 420 Primary Chain Drive Conversion Kit, which does not carry the Zero XB shim.

Where can I buy the Heavy Hitter Zero XB 420 Primary Chain Drive Conversion Kit?

Right here. We sell the Heavy Hitter Zero XB 420 Primary Chain Drive Conversion Kit at GritShift. Browse every Heavy Hitter part we carry in our Heavy Hitter collection.

Deja un comentario

Todos los comentarios son moderados antes de ser publicados