Heavy Hitter billet swingarm installed on an E Ride Pro, close-up

The Heavy Hitter Rogue Stock Length E Ride Billet Swingarm keeps the factory wheelbase of the E Ride Pro-S, Pro-SS, Pro-SS 3.0, Pro-SS 4.0 and Pro-SR while replacing the OEM arm with a one-piece welded 6061-T6 billet aluminum structure, sold here at GritShift. Its needle bearings are rated at 6,500 lbf static each, against 1,030 lb for the stock bearing.

Specs verified September 2026 against the live GritShift product page.

Specifications

Material 6061-T6 billet aluminum, one-piece welded design
Length OEM length
Finish Anodized
Weight 15 lb
Pivot bearings Upgraded needle bearings, 6,500 lbf static load per bearing (OEM: 1,030 lb per bearing)
Bearing sleeves 52100 nitrided steel, for precise fitment and correction of bearing side load
Jackshaft options Both the original jackshaft bearing and sleeve design and the upgraded design are included
Chain routing Lowered center cross support; the chain runs around it like a traditional motocross swingarm
Brake mount Machined steel brake bracket retaining pin and forged steel brake block
Axle blocks Captured, single-tool adjustment, axle block adjusters included

What bikes does the Heavy Hitter Rogue Stock Length Swingarm fit?

  • E Ride Pro-S
  • E Ride Pro-SS
  • E Ride Pro-SS 3.0
  • E Ride Pro-SS 4.0
  • E Ride Pro-SR

Why does the OEM E Ride swingarm need replacing?

Heavy Hitter's racers found that the stock E Ride Pro swingarm cannot withstand a constant beating even at stock power levels: it bends from flying through whoops, entering corners fast and landing jumps, often without the rider noticing. The Rogue was built so the team could race without a swingarm failure ending the day or damaging other components. It is welded from 6061-T6 billet into a single piece and fitted with a machined steel brake bracket retaining pin and a forged steel brake block for durability beyond the OEM design.

Which jackshaft bearing setup should I run?

The upgraded setup uses needle bearings rated at 6,500 lbf static per bearing, against 1,030 lb for the stock bearing, with a retaining sleeve machined from 52100 nitrided steel that strengthens the whole jackshaft system and reduces bearing side load. Heavy Hitter includes both the original and the upgraded bearing and sleeve designs so the choice is yours, but notes that the stock configuration reduces the force the jackshaft bolt can withstand without bending.

What is in the box?

  • Rogue stock length billet swingarm
  • Captured axle blocks with axle block adjusters
  • Upgraded needle bearings with 52100 nitrided steel sleeves
  • Original-design jackshaft bearing and sleeve option
  • Forged steel brake block and machined steel brake bracket retaining pin

Stock length or the 2.5 inch extended Rogue?

This arm keeps the E Ride at its factory wheelbase with the same welded billet construction and bearing package as the longer version. The Heavy Hitter Rogue 2.5 Inch Extended E Ride Billet Swingarm adds 2.5 in for traction, control and cornering speed, and Heavy Hitter strongly recommends pairing that longer arm with its Adjustable Height E Ride Suspension Triangle.

Where can I buy the Heavy Hitter Rogue Stock Length E Ride Billet Swingarm?

Right here. We sell the Heavy Hitter Rogue Stock Length E Ride Billet Swingarm at GritShift.

Leave a comment

All comments are moderated before being published