The EBMX X-9000 V3 Complete Light Bee Race Harness is a plug-and-play lightweight wiring harness for the Sur Ron Light Bee platform running an EBMX X9000 V3 controller, made by EBMX and sold here at GritShift. It strips out every unneeded sensor and plug, carries an encoder plug only and weighs 0.5 lb.
Specs verified October 2026 against the live GritShift product page.
Specifications
| Type | Race wiring harness, plug-and-play |
|---|---|
| Controller | EBMX X9000 V3 (sold separately) |
| Motor plug | Encoder plug only; hall-based motors must be re-wired |
| Built for | MX racing and DIY builds using the Light Bee drivetrain |
| Design | Eliminates unneeded sensors and wires, reduced wire mass |
| Weight | 0.5 lb |
| Sold as | Harness only |
| Not stated on the listing | Connector list, wire gauge, harness length, fuse or breaker provision |
What bikes does the EBMX X-9000 V3 Light Bee race harness fit?
- Sur Ron Light Bee S
- Sur Ron Light Bee X
- Segway X160
- Segway X260
- DIY builds using the Light Bee drivetrain with an X9000 V3 controller
Why run a race harness instead of the stock Light Bee wiring?
EBMX built this harness for MX racing and for DIY builds that use the Light Bee drivetrain with an X9000 V3 controller. It strips out all the unneeded sensors and plugs and leaves only what the bike needs to run, which the listing says gives a cleaner install, easier serviceability and less wire mass. The plug-and-play design is meant for quick setup on race day.
What controller and motor does the harness need?
The harness is sold on its own; the EBMX X9000 V3 controller is sold separately, and we carry it as the EBMX X-9000 V3 Controller Plug N Play Kit for the Light Bee. The harness carries an encoder plug only, so a hall-based motor will need to be re-wired before it can run on this harness. The product photo shows the harness with its labelled connectors and no other parts.
What changes on the bike with the race harness fitted?
With the unneeded sensors and wires gone, the install is simpler and repairs are easier, per EBMX, and the reduced wire mass allows a much cleaner routing on the frame. The plug-and-play design is built for quick setup on race day, per the listing. The listing names no wire gauge, harness length or fuse provision, so follow the X9000 V3 installation guide for circuit protection.
Where can I buy the EBMX X-9000 V3 Complete Light Bee Race Harness?
Right here. We sell the EBMX X-9000 V3 Complete Light Bee Race Harness at GritShift, made by EBMX. Browse every EBMX part we carry in our EBMX collection.
