The EBMX X-9000 V2 Complete Light Bee Race Harness is a plug-and-play race wiring harness for the Sur Ron Light Bee and Segway X260, made by EBMX and sold here at GritShift. It replaces the OEM harness with only the plugs and wires the bike needs to run on an X9000 controller, with a prewired headlight output, 0.5 lb.
Specs verified November 2026 against the live GritShift product page.
Specifications
| Type | Plug-and-play lightweight race harness |
|---|---|
| Controller | Wired for EBMX X9000 controllers only; controller sold separately |
| Included | Aux adapter for the X9000 controller with a prewired headlight output plug |
| Removes | All unneeded sensors, plugs and wires |
| Weight | 0.5 lb |
| Built to | EBMX quality guidelines for E-Moto Racing |
| Not stated on the listing | Harness length, wire gauge, connector part numbers, fuse or breaker provision |
What bikes does the EBMX X-9000 V2 Light Bee race harness fit?
- Sur Ron Light Bee with EBMX X-9000 V2 Controller
- Segway X260 with EBMX X-9000 V2 Controller
- DIY builds using the Light Bee drivetrain with an X9000 controller
What does a race harness remove from a Light Bee?
Everything the bike does not need to run. EBMX builds this harness for MX racing, so it carries only the plugs and wires the drivetrain needs on an X9000 controller and leaves out the OEM sensors and connectors that a race bike never uses. The listing describes the result as simplified installation, serviceability and repairs, with a reduced mass of wires that allows a much cleaner install. An aux adapter for the X9000 is already in the loom with a headlight output plug prewired, so a race light does not need its own splice.
Does it work with the stock controller?
No. EBMX wires this kit to plug and play with X9000 controllers specifically, and the listing is clear that it is the harness only; the controller is bought separately. The product page points to the EBMX X-9000 Controller Plug N Play Kit for the Light Bee and Segway we sell. The fitment line names the X-9000 V2 controller for both bikes.
Can I use it on a custom build?
Yes, that is the third fitment EBMX lists. Any DIY build that runs the Sur Ron Light Bee drivetrain with an X9000 controller can use this harness in place of an OEM loom that would otherwise have to be stripped of its unused plugs. The photo shows the loom with its labelled connectors and nothing else; the listing names no fuse or breaker, so circuit protection is on the builder. For X-9000 V3 setups, EBMX also makes the X-9000 V3 Complete Light Bee Race Harness.
Where can I buy the EBMX X-9000 V2 Complete Light Bee Race Harness?
Right here. We sell the EBMX X-9000 V2 Complete Light Bee Race Harness at GritShift, made by EBMX. Browse every EBMX part we carry in our EBMX collection.
