Our On The Rox Intake Reinforcement Bracket keeps the factory intake boot planted even during extreme boosting conditions. After many miles of hard boosting on test Roxors, we have not had any leaks after the installation of this hold down. No more getting out to re-adjust the intake boot on the side of the highway between L.A. and Vegas!
If you’re reading this, you have probably encountered the Roxor’s flawed intake design. The intake boot can begin to leak under hard boosting. This boost leak causes a variety of problems – throwing codes, running rich, bogging down, an audible air leak, and a serious loss of power.
If you’re thinking “that’s only for modified Roxors,” think again! This boost leak is commonly encountered at highway speeds in excess of 60 MPH, but it’s been known to happen on factory ECU tunes at much lower speeds!
We highly recommend this as an add-on to any ECU tune.
- Easy installation utilizing stock hardware and mounting holes
- Prevent boost leaks commonly encountered from the intake design
- Prevent performance loss
- 1 Intake Hold Down
18-22 Mahindra Roxor