Warp 9 E-Moto Elite foot peg installed on a Sur Ron, close-up

Warp 9 Racing makes the E-Moto Elite Foot Pegs sold here at GritShift from forged 7075 T6 aluminum for the Sur Ron Light Bee X, S and 2 X, Segway X260, E Ride Pro-S, SS, SS 3.0 and SR, 79Bike Falcon, Ventus One and Zero XB. The 89 x 58 mm platform sits 1/4 in behind stock, 1.2 lb.

Specs verified October 2026 against the live GritShift product page

Specifications

Material Forged 7075 T6 aluminum, CNC machined after forging
Platform 3-5/8 by 2-3/8 in (89 x 58 mm)
Position 1/4 in back from the OEM peg location
Teeth Stainless steel, installed
Hardware Uses the OEM springs and pivot pins
Finish Seven anodized colors (Silver, Black, Red, Blue, Magnesium, Gold, Purple) or White powder coat
Weight 1.2 lb
Fitment Sur Ron Light Bee X, Sur Ron Light Bee S, Sur Ron Light Bee 2 X, Segway X260, E Ride Pro-S, E Ride Pro-SS, E Ride Pro-SS 3.0, E Ride Pro-SR, 79Bike Falcon Pro, 79Bike Falcon GT, Ventus One, Zero XB

What bikes do the Warp 9 E-Moto Elite Foot Pegs fit?

  • Sur Ron Light Bee X / S and Segway X260
  • Sur Ron Light Bee 2 X
  • E Ride Pro-S / Pro-SS / Pro-SS 3.0 / Pro-SR
  • 79Bike Falcon Pro / GT
  • Ventus One
  • Zero XB

What is wrong with the stock Light Bee and E Ride pegs?

Warp 9 describes the stock e-moto pegs as small and slippery once they pick up mud. The Elite peg is a 3-5/8 by 2-3/8 in (89 x 58 mm) forged platform with stainless teeth already installed, which gives the boot something to bite into in any conditions and lets you steer with your feet instead of hanging on the bars. Forging and then machining the 7075 T6 body is what Warp 9 credits for surviving rock strikes and hard landings that fold cheaper cast pegs.

Does the 1/4 in setback change the riding position?

The platform sits 1/4 in back from the OEM peg location, so the peg lands a touch rearward of stock on every bike it fits. Warp 9 presents it as a wider platform to stand on, and the figure is the same on the Light Bee, E Ride Pro, 79Bike Falcon, Ventus One and Zero XB.

What do you reuse from the bike when fitting the Elite pegs?

The pegs mount with the OEM springs and pivot pins, so keep both when you remove the stock pegs. Warp 9 calls it one bolt-on swap. Eight finishes are offered: seven anodized colors plus white powder coat.

Where can I buy the Warp 9 E-Moto Elite Foot Pegs?

Right here. We sell the Warp 9 E-Moto Elite Foot Pegs at GritShift, made by Warp 9 Racing. Browse every Sur Ron Light Bee X part we carry in our Surron LBX Parts collection.

Laisser un commentaire

Tous les commentaires sont modérés avant d'être publiés