Sur Ron Ultra Bee OEM rear brake caliper and rotor installed, close-up

The Sur Ron OEM Rear Brake System sold here at GritShift is the genuine factory rear brake for the Sur Ron Ultra Bee and Ultra Bee HP 2026, part number 52200-YQ5C-0100: master cylinder, hand lever with parking brake, bar clamp, brake switch, hose and caliper with pads, plus the caliper support and its M5 x 10 screws.

Specs verified November 2026 against the live GritShift product page.

Specifications

Type Genuine Sur Ron OEM rear brake system, hand lever operated, complete from bar to caliper
Maker part number 52200-YQ5C-0100
Included Master cylinder, lever with parking brake, bar clamp, brake switch, hose, caliper with pads, caliper support, pad pin, pad retaining spring, (2) P clips, (2) M5 x 10 screws
Parking brake Built into the lever; it locks on to hold the bike on a slope when parked
Bar clamp Plain clamp, no rearview mirror base
Pads Same pad set as the Ultra Bee front brake, so one spare set covers both ends
Caliper alone The rear caliper is also sold on its own (linked below)
Fitment Sur Ron Ultra Bee and Ultra Bee HP 2026

What bikes does the Sur Ron OEM Ultra Bee rear brake system fit?

  • Sur Ron Ultra Bee
  • Sur Ron Ultra Bee HP 2026

Why replace the whole Ultra Bee rear brake instead of one part?

The Ultra Bee rear brake is worked by a hand lever on the bar, and that lever does two jobs: it slows the back wheel and it locks on to hold the bike on a slope when parked. When the lever is bent from a crash, or the bike no longer stays put, the fault can sit at the bar, in the hose or down at the wheel. One system replaces all of it in a single job, every part new and from Sur Ron, so there is no guessing which piece failed.

What comes in the box with the rear brake system?

The master cylinder with its parking brake lever, the bar clamp, the brake switch, the hose and the caliper with pads arrive as one assembly. The small parts are the caliper support, the pad pin, the pad retaining spring, two P clips for routing the hose and two M5 x 10 screws. The clamp at the bar has no rearview mirror base. If only the caliper is damaged, the Sur Ron OEM Rear Brake Caliper for the Ultra Bee can be bought by itself.

How do I install the Ultra Bee rear brake system?

Lift the bike so the rear wheel is off the ground, unbolt the old caliper from its support, free the hose from its clips along the swingarm and frame, and loosen the clamp to take the old master cylinder off the bar. Fit the new master cylinder in the same spot on the bar, route the hose along the factory path with the two P clips, and bolt the new caliper on its support in place of the old one; the two M5 x 10 screws are in the kit. The pad set is the same one the front brake uses, so a single spare set serves both ends of the bike. Torque the caliper and master cylinder bolts to the figures in the Sur Ron service documentation, and check the parking lock holds the bike on a slope before riding.

Where can I buy the Sur Ron OEM Ultra Bee rear brake system?

Right here. We sell the Sur Ron OEM Rear Brake System - Ultra Bee at GritShift, made by Sur Ron. Browse every Sur Ron Ultra Bee part we carry in our Sur Ron Ultra Bee Parts collection.

Laisser un commentaire

Tous les commentaires sont modérés avant d'être publiés